A Homemade DRO for the 7x Mini-Lathe
This article describes how I added an easy-to-make DRO (Digital Readout) to the cross-slide of my 7×12 mini-lathe. It uses an inexpensive digital dial indicator that I bought from Harbor Freight for...
View ArticleInexpensive DIY tachometer for a mill or lathe
Here’s an idea I haven’t seen before. Adam made a very inexpensive tachometer for his variable speed X2 mini-mill using a cyclometer (bicycle speedometer). Almost any wired cyclometer will work and...
View ArticleSnub’s ball turning tool
I think this is a brilliant idea. “Snub” made a ball turning tool and used a 4-jaw chuck as the base. He says it works perfectly and leaves an almost perfect finish. I don’t doubt him because of the...
View ArticleCarriage Lock Modification for 8×12 or 8×14 Lathe
This is Steve Shyver’s carriage lock modification for a Harbor Freight 8×12 or Lathemaster 8×14 lathe (both lathes are the same size if measured the same way). His handle replaces the easy-to-misplace...
View ArticleNew V-belt makes speed changes easier
Changing the spindle speed of your Harbor Freight 8×12 or Lathemaster 8×14 lathe will probably be easier if you replace the factory belt with a size 3L300, which you can buy at most auto parts stores...
View ArticleRear-mounted Parting Tool Holder for Sherline Lathe
This is the rear-mounted parting tool holder for my Sherline lathe. It’s based on a design that’s been around for decades and I made it about 12 years ago, before Sherline offered one for sale. It is...
View Article
More Pages to Explore .....